Makita JV001G Manual De Instrucciones página 10

Dust extraction
Optional accessory
The dust nozzle is recommended to perform clean
cutting operations.
To attach the dust nozzle on the tool, insert the hook of
dust nozzle into the hole in the base.
Fig.13
► 1 . Dust nozzle 2. Base
To secure the dust nozzle, tighten the clamp screw at
the front of the dust nozzle. The dust nozzle can be
installed on either left or right side of the base.
Fig.14
► 1 . Clamp screw
Then connect a Makita vacuum cleaner to the dust
nozzle.
1
Fig.15
► 1 . Dust nozzle 2. Hose for vacuum cleaner
Turn the tool on without the jig saw blade making any
contact and wait until the jig saw blade attains full
speed. Then rest the base flat on the workpiece and
gently move the tool forward along the previously
marked cutting line.
1
2
► 1 . Cutting line 2. Base
1
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
2
10 ENGLISH
OPERATION
CAUTION:
Always hold the base flush with
the workpiece. Failure to do so may cause jig saw
blade breakage, resulting in a serious injury.
CAUTION:
Advance the tool very slowly when
cutting curves or scrolling. Forcing the tool may
cause a slanted cutting surface and jig saw blade
breakage.
1
Fig.16
Bevel cutting
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before tilting the base.
Fig.17
2