Publicidad
Idiomas disponibles
Idiomas disponibles
EN
USING YOUR SMART AIR PURIFIER (CONT.)
Air Quality Indicator Chart
Indicator
Color
Blue
Green
Orange
Red
Light Detection
You can turn on/off Light Detection in the VeSync
app. When this mode is turned on, the light sensor
will automatically adjust air purifier settings based
on the amount of light in the room.
The display will automatically turn off when
•
the room gets dark. If the air purifier is in Auto
Mode or Pet Mode, it will not use the high
or turbo fan speeds, even if the air quality is
poor, to avoid making too much noise.
When the room becomes light again, the air
•
purifier will return to its previous settings. The
display will automatically turn back on, and
Auto Mode will no longer be limited.
Timer
You can manually set the timer for 2, 4, or 8 hours
using the
button. You can also set the timer for
1–24 hours through the VeSync app.
Tap
repeatedly to select a time. The timer
1.
will start automatically.
Note:
The indicators are not buttons and cannot be
•
used to select a time.
The timer indicators will light up blue when active.
•
When the timer is set through the VeSync app,
•
the
indicator will light up instead. Once the
timer has finished, the air purifier will turn off.
To cancel the timer, tap
2.
indicators are off. You can also turn the timer
off in the VeSync app.
Note:
You can change the fan speed at any time
•
while the timer is on.
The timer will restart if the time is changed.
•
Pet Mode
Pet Mode is efficient at filtering allergens from
the air while conserving energy.
Tap
to turn Pet Mode on.
1.
will light up while Pet Mode is on.
2.
6
Air
Auto Mode
Quality
Fan Speed
Very Good
Sleep Mode
Good
Low
Moderate
Medium
Bad
High
until all timer
The air purifier will run for 15 minutes at high
3.
speed (3 indicator lights), then 60 minutes
at medium speed (2 indicators), and cycle
between the two fan speeds.
Pet Mode will stay on unless you select a
4.
different mode or fan speed.
To switch from Pet Mode, tap Auto Mode,
5.
Sleep Mode, or select a fan speed on the air
purifier's display or in the VeSync app.
Note:
If the light sensor detects the room is dark,
•
the display will turn off and limit Pet Mode
to medium fan speed (2 indicators), to avoid
making too much noise.
When the light sensor detects that the room
•
is lit again, Pet Mode will no longer be limited,
and the air purifier will run at medium fan
speed (2 indicators) for 30 minutes, then run
at high (3 indicators) for 15 minutes.
After this, the normal Pet Mode cycle will start
•
(15 minutes at high speed, then 60 minutes at
medium speed).
Display Lock
When the air purifier is on, you can lock the
display to prevent settings from being accidentally
changed. Buttons will not respond to being tapped.
Press and hold
for 3 seconds to lock the
1.
display. The Display Lock Indicator will light up
above the
button.
If the display is turned off, the Display Lock
Note:
Indicator will flash 3 times to show that the display
has been locked, then turn off.
The Display Lock Indicator will blink when any
2.
other button is tapped to indicate that Display
Lock is on.
Press and hold
again for 3 seconds to unlock
3.
the display. The Display Lock Indicator will turn off.
Standby Mode
The air purifier is in Standby Mode when it is
turned off, but plugged in.
Note:
In Standby Mode, the infrared dust sensor
•
will still detect the surrounding air quality and
give you updates in the VeSync app.
Display Lock (available in the VeSync
•
app) can be used while the air purifier is in
Standby Mode to keep the air purifier from
being turned back on.
Publicidad
