King Tony 9DM1371 Manual De Instrucciones página 11

2-2-6 Resistance Measurements
EN
FR
Before taking any in-circuit measurement, remove power from
the circuit being tested and discharge all capacitors in the
ES
circuit.
Connect red test lead to " Ω " jack and black test lead to " COM " jack.
1
Set Range Switch to " Ω
2
function.
Connect test lead to the circuit being measured and read the
3
resistance value on LCD.
18
WARNING
" range and press button to " Ω "
2-2-7 Continuity Measurements
WARNING
Before taking any in-circuit measurement, remove power from
the circuit being tested and discharge all capacitors in the
circuit.
Connect red test lead to " Ω " jack and black test lead to "COM " jack.
1
Set Range Switch to " " range, by pressing
2
Remove power from the circuit being tested and discharge all
3
capacitors.
Connect test lead to the circuit being measured.
4
When the impedance between the test jack is lower than 40Ω, it will
5
activate a continuous beeper ( 2KHz).
Note:
Continuity Test is available to check open/short of
the circuit.
Open circuit
EN
FR
ES
button.
Short circuit
19