Publicidad
Idiomas disponibles
Idiomas disponibles
MAX/MIN recording button:
4
MAX
EN
MIN
Press
button to enter the maximum and minimum
MAX
MIN
FR
recording mode, select the proper range before using
MAX/MIN to ensure that reading value will not exceed
ES
the measurement range. Press the button once to select
MAX value.
Press it again to select MIN value, and press again to
select current value with
Press and hold down
the MAX MIN mode.
AC/DC Current Select and
5
• To select function AC or DC in current Ampere range.
• To select continuity measurements or Resistance
measurement at
Function Selector Switch:
6
For power OFF and selection of desired Function
Range.
COM Measuring Connector:
7
To connect negative lead (black test lead) for voltage,
frequency, current, resistance, diode and continuity
measurement.
10A Measuring Connector:
8
To connect positive lead (red test lead)for current
measurement below 10A.
12
annunciator blinking.
MAX
MIN
button for 1 second to exit
MAX
MIN
/ Ω Select Button:
/ Ω range.
VΩ,μA, mA, Hz,
Measuring Connector:
9
To connect positive lead ( red test lead ) for voltage,
diode, frequency, microampere, milliampere and
continuity measurement.
Note:
To avoid blowing an input fuse, use the 10 A jack
until you are sure that the current is less than
400mA. When Doing Current Measurement.
Tilt stand:
EN
FR
ES
13
Publicidad
