Publicidad
Idiomas disponibles
Idiomas disponibles
Check whether the machine has been mounted correctly.
Check whether the cable has been wound up correctly.
Make sure that the load is well attached to the hook and
that it is not out of balance more than 15°.
Immediately switch off the machine when it appears that
the load cannot or hardly be winched.
Constantly keep an eye on the load during the operation.
Stop the operation as soon as the red part of the cable
becomes visible. The red part of the cable may not be
unwound.
When switching off the machine while lowering, the load
may drop a few centimetres more. This is a normal
condition, which does not indicate a defect of the machine.
To switch on the machine, turn the red on/ off switch (1) to
the right so that it comes forward.
To switch off the machine, press the red on/off switch (1).
To lift the load, press the up/down switch (2) at the side of
the arrow pointing upward.
To lower the load, press the up/ down switch (2) at the side
of the arrow pointing downward.
Release the up/down switch (2) as soon as the load has
been winched to the desired position.
During an upward movement the end disc (5) will
eventually touch the brace at the bottom of the machine.
When
this
happens,
automatically.
the
machine
switches
The machine does not require any special maintenance.
Regularly clean the ventilation slots.
Regularly check the machine for possible damages.
Before use always check the condition of the cable. In
particular check at full length whether the cable shows any
buckles or frays. Have a damaged cable replaced before
putting the machine back into operation.
From time to time, apply a drop of oil to the bearing of the
motor.
The packaging is made up of recyclable materials,
which you can dispose on local recycling points.
Never dispose of power tools with your household
waste!
According to the European Directive 2012/19/EC on
electrical and electronic equipment waste and its
transposition into national law, power tools must be
collected separately and delivered to the collection sites
provided for this purpose.
You can get information regarding the disposal of the power
tool through the person in charge for recycling in your city.
WhatsApp:
+351 967 817 569
E-mail:
support@vito-tools.com
off
Publicidad
