Publicidad
Idiomas disponibles
Idiomas disponibles
5.4
Fall arrest
2
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only the Hilti tool tether #2261971.
▶ Use the loop to secure the tool tether to the product as shown in the illustration. Check that it holds
securely.
▶ Secure the carabiner to a load-bearing structure. Check that the carabiner holds securely.
Comply with the operating instructions of the Hilti tool tether.
5.5
Fitting the side handle
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the tool holder from the front and into the recess provided.
3. Set the side handle to the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
5.6
Fitting the depth gauge (optional)
1. Release the side handle clamping band by turning the handle grip.
2. Release the screw at the depth gauge.
3. Slide the depth gauge from the front into the 2 guide holes provided.
4. To set the drilling depth, adjust the depth gauge to the desired drilling depth.
5. Tighten the screw at the depth gauge.
6. Tighten the side handle clamping band by turning the handle grip.
5.7
Fitting/removing the accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
1. Apply a little grease to the connection end of the accessory tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
▶ The product is ready for use.
3. Pull the tool lock back as far as it will go and remove the accessory tool.
Use only the recommended grease supplied by Hilti. Use of unsuitable grease may cause damage
to the product.
6
Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1
Drilling with hammering action (hammer drilling)
1. Set the function selector switch to the "Hammer drilling" position
2. Press the drill bit against the work surface.
3. Press the control switch.
▶ The product starts.
*2373842*
3
4
5
2373842
6
.
English
9
Publicidad
