Publicidad
Idiomas disponibles
Idiomas disponibles
7
7G
7A
7D
7E
7C
7 TRIM FLANGE ATTACHMENT
Position Flange (7A) on Valve (7B) with Drain Hole (7C) at the bottom. Place
Protective Washer (7D) on the short end of the reversible Retainer Sleeve
(7E). Screw Retainer Sleeve (7E) onto threaded section of the Stem and
Bonnet (7G). Tighten Retainer Sleeve (7E) by hand until Flange (7A) is snug
to finished wall surface. If the short end of the Retainer Sleeve (7E) is too
short, reverse it to use the longer end.
8
8B
8A
8D
8C
8E
8 HANDLE ATTACHMENT
Screw Stem Extender (8A) onto the Valve Stem (8B). Thread the Set Screw (8C)
into the Handle (8D) and thread it in only three to four turns. Place Handle (8D)
onto the Stem Extender (8A) and tighten the Set Screw (8C) by using the Hex
Wrench (8E) that is provided.
Make sure Set Screw (8C) is securely tightened to handle (8D).
ENGLISH
7B
7C
9
9B
9A
9 SHOWER ARM INSTALLATION
Insert the end of Shower Arm (9A) through the Shower Flange (9B).
Apply PTFE plumber's tape to back end of Shower Arm (9A) according to
manufacturer's instructions. Screw the end of Shower Arm (9A) into pipe
elbow inside the wall. Slide Shower Flange (9B) tight to the wall.
10
10B
10
SPOUT INSTALLATION
Apply PTFE plumbers tape on both ends of Pipe Niple (10A) (not included).
Screw Pipe Niple (10A) into the elbow inside the wall and tighten with pipe
wrench. The Pipe Niple (10A) is to project 3
wall. Screw Tub Spout (10B) onto Pipe Niple (10A) and tighten until Spout is
properly positioned and flush to the finished wall.
11
11A
11E
11 ARM MOUNT & HOSE INSTALLATION
Screw Arm Mount (11A) into the end of Shower Arm (11B). Connect Hose (11C)
into the Arm Mount Outlet (11D) by turning Metal Hose Fitting (11E).
3
10A
7
/ 8 " to 4 "
3
7
/
" to 4" from the finished
8
11B
11D
11C
Publicidad
