Descargar Imprimir esta página

VOSS.farming profiCUT 85305 Instrucciones De Operación página 23

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 76
INSTRUCTION MANUAL VOSS.FARMING PROFICUT
8.2
CLEANING THE AIR FILTER
Clean the air filter regularly. The cleaning cycle depends on the frequency of use. Clean
the air filter as soon as you detect any contamination in the air filter at the latest.
1. Switch off the clipper and disconnect the clipper from the power supply.
2. Remove impurities around the air filter.
3. To clean the air filter (5), push the air filter (5) out and clean the filter with the
enclosed cleaning brush (fig. 6).
NOTICE
Make sure that no foreign bodies or impurities enter the machine during cleaning.
4. Put the air filter (5) back into the clipper.
WARNING
Do not use the clipper without an air filter.
9
MAINTENANCE
Carry out regular visual checks. Check the machine for damage before each use.
CAUTION
Do not use the machine if there is visible damage.
9.1
SHARPENING BLADES
CAUTION
The sharpening of the blades may only be carried out by specialist dealers using
specialist equipment. Do not sharpen the blades yourself.
10
TROUBLESHOOTING
NOTICE
► Do not make any improper changes or modifications to the unit.
► Never open the housing. Contact the service department for repairs.
If the device malfunctions or is found to be otherwise defective, even after following
the suggested solutions below, contact the service department. The contact details can
be found in chapter 14.
Fault/Problem
Motor does not
run
85305 - 07.2021 - V2
Motor
Cause
1. No current
2. Cable, Switch or
motor defective
Solution
1. Check the socket and fuse used and
have them checked/replaced by
qualified personnel if necessary.
2. Contact the service department.
DE
EN
EN
FR
IT
NL
SV
ES
PL
23

Publicidad

loading