Publicidad
14
www.raider.bg
should be done gradually, as periodically removed
from the drill hole to remove chips or dust. If during
drilling to drill holes in zaklini, you should exclude
drill. Use a change of direction of rotation to remove
the drill from the hole. Drill must be kept in alignment
with the hole. Ideally, the drill should be placed
perpendicular to the surface of the material being
processed. If the condition for perpendicularity is not
respected at work can lead to trapped or breakage
in drill hole and injury to the user. Continued drilling
at low speed the engine from overheating threatens.
Must make periodic breaks during work or to allow
the drill to work on no-load maximum speed for about
3 minutes. Do not obscure the openings in the hull
used for ventilation of the engine.
8.13. Outdoor use.
Switch the machine only in installations equipped
with electric switch "Fi" RCD (Residual Current
Device). RCD must be no more than 30 mA. Use an
extension cord suitable for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of electric
shock.
Make periodic breaks at work.
Keep and refer to the accessories carefully.
Do not throw the tool, do not overload, do not soak
in water and other liquids do not use it for mixing
adhesives and concrete coatings.
9. Service and support.
9.1. Impact drill does not require additional
lubrication or special maintenance. There are no
parts requiring maintenance by the user. Never use
water or any liquid chemical cleaning drill. It should
only be wiped with a piece of dry tissue. Should
always be stored in a dry place and ventilation holes
in the body of the drill to be free.
9.2. Replacing carbon brushes.
Exports (shorter than 5 mm), up or broken engine
carbon brushes should be replaced. Always replace
both brushes simultaneously. Work on replacement
of carbon brushes entrusted only to qualified person
with original spare parts in service of business
RAIDER.
9.3. The repair of your power is best carried out
only by qualified specialists in workshops RAIDER,
which used only original spare parts. Thus ensuring
their safe operation.
10. Environmental protection.
In view of environmental power, additional
accessories and packaging must be subjected to
appropriate processing for reuse of the information
contained in these materials.
Do not dispose of household waste power! Under
the EU Directive 2002/96/EC on scrapped electrical
and electronic equipment and promoting law and
national power, which can be used more, must be
collected separately and be subjected to appropriate
processing for recovery of contained therein scrap.
Publicidad
