BLACK&DECKER BBC10 Manual De Instrucciones página 22

C C A A U U T T I I O O N N : : T T O O R R E E D D U U C C E E T T H H E E R R I I S S K K O O F F I I N N J J U U R R Y Y O O R R P P R R O O P P E E R R T T Y Y D D A A M M A A G G E E : :
• Pull cord by plug rather than cord when disconnecting the 120 or 220 Volts AC Charging Adapter from the unit.
• NEVER ATTEMPT TO JUMP-START OR CHARGE A FROZEN BATTERY.
• To recharge this unit, use only the supplied AC Charging Adapter.
• Vehicles that have on-board computerized systems may be damaged if vehicle battery is jump-started. Before jump-
starting, read the vehicle's owner's manual to confirm that external-starting assistance is suitable.
• When working with lead acid batteries, always make sure immediate assistance is available in case of accident or
emergency.
• Always have protective eyewear when using this product: contact with battery acid may cause blindness and/or
severe burns. Be aware of first aid procedures in case of accidental contact with battery acid.
• Have plenty of fresh water and soap nearby in case battery acid contacts skin.
• If battery acid contacts skin or clothing, wash immediately with soap and water for at least 10 minutes and get
medical attention immediately.
• Never smoke or allow a spark or flame in vicinity of vehicle battery, engine or charger.
• Remove personal metal items such as rings, bracelets, necklaces and watches when working with a lead acid
battery. A lead acid battery can produce a short circuit current high enough to weld a ring, or the like of a metal,
causing a severe burn.
• Never allow battery acid to come in contact with this unit.
• Do not operate this unit in a closed area or restrict ventilation in any way.
• F F I I R R S S T T A A I I D D – SKIN: If battery acid comes in contact with skin, rinse immediately with water, then wash thoroughly
with soap and water. If redness, pain, or irritation occurs, seek immediate medical attention.
EYES: If battery acid comes in contact with eyes, flush eyes immediately, for a minimum of 15 minutes and seek
immediate medical attention.
D D A A N N G G E E R R : : N N E E V V E E R R A A L L T T E E R R A A C C C C O O R R D D O O R R P P L L U U G G P P R R O O V V I I D D E E D D . . – If it will not fit outlet, have proper outlet installed by a
qualified electrician. Improper connection can result in a risk of an electric shock.
P P r r e e p p a a r r i i n n g g t t o o C C h h a a r r g g e e
1. Determine voltage of battery to be charged by referring to the vehicle manual.
2. it is necessary to remove battery from vehicle to charge, or to clean terminals, always remove grounded
terminal from battery first. Make sure all accessories in the vehicle are off, so as not to cause an arc.
3. Clean battery terminals. Do not allow corrosion to come in contact with eyes.
4. Add distilled water in each cell until battery acid reaches level specified by battery manufacturer. This helps
purge excessive gas from cells. Do not overfill. For a battery without cell caps (maintenance free), carefully
follow manufacturer's charging instructions.
5. Study all battery manufacturer's specific precautions, such as removing or not removing cell caps while
charging, and recommended rates of charge.
6. Remove battery completely from boat/airplane or any confined area before charging.
7. Make sure the initial charging rate does not exceed battery manufacturer's requirement.
C C h h a a r r g g e e r r L L o o c c a a t t i i o o n n
1. Locate charger as far away from battery as cables permit.
2. NEVER place charger directly above battery being charged; gases from battery will corrode and damage charger.
3. NEVER allow battery acid to drip on charger when reading gravity or filling battery.
4. NEVER operate charger in a closed-in area or restrict ventilation in any way.
5. Marine batteries must be removed and charged on shore.
6. Do not set a battery on top of charger.
D D C C C C o o n n n n e e c c t t i i o o n n P P r r e e c c a a u u t t i i o o n n s s
1. Connect and disconnect DC output clamps only after removing AC cord from electric outlet.
2. Never allow clamps to touch each other.
3. Attach clamps to battery and chassis as indicated in "Battery Installed in Vehicle" steps 5 and 6, and in "Battery
Outside of Vehicle" steps 2, 4 and 5.
Follow these steps when the battery is installed in a vehicle. A spark near the battery may cause an explosion.
W W A A R R N N I I N N G G : : T T O O R R E E D D U U C C E E R R I I S S K K O O F F A A S S P P A A R R K K N N E E A A R R T T H H E E B B A A T T T T E E R R Y Y : :
22