MSW Motor Technics MSW-GW-120EE Manual De Instrucciones página 15

3.2. Preparation for operation
POSITIONING OF THE UNIT
The ambient temperature must not exceed 40°C and ambient humidity should not exceed 85%. Place the unit
in a way that ensures good air circulation. Maintain a minimum clearance of 10 cm from any wall of the unit.
Keep the unit away from any hot surfaces. Always operate the unit on a level, stable, clean, fireproof, and dry
surface and out of the reach of children and persons with impaired mental, sensory, and intellectual
functions. Place the unit in such a way that the main plug can be reached at any time. Ensure that the power
supply to the unit corresponds to that specified on the identification plate!
3.3. Working with the unit
Do not apply too much pressure when engraving.
WARNING! The use of accessories or attachments other than those recommended in this manual may present
a risk of personal injury. To use this tool correctly, the safety regulations, installation instructions and
operating instructions contained in this manual must be followed. All persons using and servicing the device
must read this manual and be informed of potential dangers. Children and minors are not allowed to use this
tool. Children should be supervised at all times if they are in the area where the tool is being used. It is also
necessary to comply with the accident prevention regulations in force in your region. The same applies to
general health and safety rules.
The manufacturer is not responsible for any changes made to the tool or for any damage resulting from such
changes.
Even if the tool is used as intended, it is not possible to eliminate all remaining risk factors. Due to the design
and construction of the tool, the following hazards may occur:
• Injury to the lungs if an effective dust mask is not worn.
Hearing damage if effective ear muffs are not worn.
•
• Eye damage if safety glasses are not worn.
• Risk of injury if hands are not kept away from the cutting tools.
EN
3 - Stroke adjustment knob:
4 - Tip release screw / 5 - LED light: