Publicidad
Idiomas disponibles
Idiomas disponibles
Cable jumper
Lead out the cable from the wiring hole.
The cable is led out from the wiring hole for about 200~300mm.
※ Do not pull the cable hard. Otherwise, it will lead to disconnection.
Cable jumper
Connect with the cable on the back of the
TV host.
After connection, please be sure to wrap
self-fluxing tape around each connector
and take waterproof measures.
※ Do not re-plug the cable when the
power box is electrified.
Otherwise, it will lead to failure.
Please put the TV in a stable place
where there is no danger of falling.
In addition, please be careful not to
damage the surface of the picture.
8
After connection, use self-fluxing
adhesive tape to make waterproof
measures.
Temporarily set the TV main body
Perform initial setting and action confirmation.
Install the TV main body on the installation fitting.
1. Align the slot of the TV main body with two claws on the upper part of the mounting
bracket for installation.
※ Please hang the main
body on the upper jaw,
and then aim at the lower
part.
2. Fix the lower part of the mounting
bracket at 2 places with screws.
9
Publicidad
