Absaar SL Serie Instrucciones De Uso página 14

DireCTions of Use
After the charging process is completed:
• Power the charger off.
• Unplug the power cord from the wall outlet.
• Disconnect the negative clamp (black cable) of the charger from the negative battery pole.
• Disconnect the positive clamp (red cable) of the charger from the positive battery pole.
8. JUmP-StArt
SL and SLS series chargers feature a jump-start function. If your vehicle engine does not start, you can use this
function to jump-start the engine in order to get back on the road quickly. To jump-start your engine:
• Connect the charger clamps to the poles of the installed vehicle battery respecting the polarity.
Make sure that they have a good electrical contact.
• Set the voltage selector switch according to the battery's nominal voltage.
• Connect the device to the wall outlet and set the mode selector switch to the „Jump Start" position.
• Set the current selector switch to level 6 (for the SLS series only).
• To jump-start the vehicle engine, press the wired remote control button and start the engine at the
same time.
• Once the vehicle engine has started, release the remote control button.
• If the engine jump-start fails, the built-in breaker will release after approx. 30 seconds.
• After cooling down for 3 to 5 minutes, the breaker can be pushed in again and you can repeat the above
procedure. If necessary, check the vehicle ignition system and electrical systems.
• Also check the User's Manual for your vehicle.
• We recommend that you first pre-charge the battery for approx. 5 to 10 minutes.
9. inStAlling thE hAndlE, StAnd And WhEElS
A handle, a stand and two wheels are supplied with the charger. Please make sure you mount them properly when
assembling these accessories.
3. Install the stand at the bottom
of the device by using 2 sheet
metal screws.
1. Pull the handle up to
the fixation hole.
2. Fix the handle on the left and right
sides by using 2 sheet metal
screws.
14