Duronic FN16 Manual De Instrucciones página 9

ADJUSTING THE ANGLE
1. To make adjustments to the angle
of the fan, switch it off and adjust it
by hand to the desired angle using
minimal force.
2. If the fan doesn't adjust using minimal
force, loosen the adjusting Nuts(4)
slightly at the side of the fan by turning
them anti-clockwise.
3. Adjust the fan head to the desired
angle and then tighten the nuts again
by turning them clockwise.
1. Unscrew the Safety Screws(7) around the rim of the Safety Grill(1).
2. Lift off the top half of the safety grill upward to release it.
3. Use a duster or soft dry cloth to remove any dust build-up on the Fan Blades(3)
and safety grill.
4. Place the top half of the safety grill back on to the fan and screw back in place.
Cleaning and Maintenance
9
4