Bosch GWI 10,8 V-LI PROFESSIONAL Instrucciones De Servicio página 14

OBJ_BUCH-134-004.book Page 3 Monday, April 24, 2006 9:11 AM
Hold the machine only by the insulated grip-
ping surfaces, when performing an operation
where the cutting tool may run into hidden
wiring. Contact with a "live" wire will make exposed
metal parts of the tool "live" and shock the operator.
Hold the machine with a firm grip. High reaction
torque can briefly occur while driving in and loosen-
ing screws.
Functional Description
Read all safety warnings and all
instructions. Failure to follow the warn-
ings and instructions may result in electric
shock, fire and/or serious injury.
While reading the operating instructions, unfold the
graphics page for the machine and leave it open.
Intended Use
The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal, ceramic
and plastic, especially at hard to reach locations.
Product Features
The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Locking sleeve
2 Tool holder
3 Screwdriver bit*
4 Rotational direction switch
5 On/Off switch
6 Torque selector switch
7 Release button for angle selection of drill head
8 Soft grip
9 Utility clip
10 Battery unlocking button
11 Battery
12 Drill bit with hexagon shank*
13 Universal bit holder*
*The accessories illustrated or described are not
included as standard delivery.
Noise/Vibration Information
Measured values determined according to EN 60745.
Typically the A-weighted sound pressure level of the
machine is lower than des 70 dB(A).
While working, the noise level can exceed 85 dB(A).
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
2 609 140 379 • 24.4.06
The vibration emission level given in
WARNING
this information sheet has been meas-
ured in accordance
ised test given in EN 60745 and may be used to
compare one tool with another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information sheet.
This could lead to a significant underestimate of expo-
sure when the tool is used regularly in such a way.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given period
of work should also take into account the times when
the tool is switched off and when it is running but not
actually doing the job. This may significantly reduce the
exposure level over the total working period.
Technical Data
Cordless angle drill/driver
Article number
Rated voltage
No-load speed
Max. torque for hard/soft
screwdriving application
according to ISO 5393
Max. screw dia.
Max. drilling dia.
– Steel
– Wood
Weight according to
EPTA-Procedure 01/2003
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
Declaration of Conformity
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents: EN 60745 according to
the provisions
98/37/EC.
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
2
.
English–3
with a standard-
GWI 10,8 V-LI
PROFESSIONAL
3 601 C60 U..
V=
rpm 0 – 585
Nm
mm
mm
mm
kg
of the directives 89/336/EEC,
Dr. Eckerhard Strötgen
Head of Product
Certification
10.8
13/5
5
8
10
1.1