Packaging Contents - Oehlbach FALCON HD Manual Del Usuario

7. Make sure the transmitter and receiver are pointing towards each other using the triangular indicators
on the top as a guide. This enables the best transmission quality to be achieved.
8. The installation is now complete. If no image is displayed on the output device, first press the Mode
button on the receiver and then the Mode button on the transmitter. The connection should now be
established, with an image displayed on the output device.
Operation
1. To establish a connection between the receiver and the transmitter, first press the PAIRING button on
the receiver.
2. An image should now appear on the output device with the message: „Connecting through Pairing".
3. Then press the PAIRING button on the transmitter.
4. The connection is established after a few seconds and the „Connected" message appears on the
output device. The video signal of the source device is then transmitted.

Packaging contents

· Falcon HD transmitter
· Falcon HD receiver
· IR emitter with 2.5mm jack plug
· IR receiver with 3.5mm jack plug
· 2 x 1.5 m HDMI cable
· 2 x 5v DC power adaptor
· Instruction manual
Troubleshooting
1. If no image appears on the output device:
· Make sure all the devices are wired and connected correctly. To do this, follow the installation and
operating instructions step by step.
· Make sure you only use up-to-date HDMI „high-speed" cables. To guarantee unrestricted signal
transmission, you should use Oehlbach HDMI cables.
· If an image still does not appear, disconnect the power supply from the Falcon HD and restart the
receiver and transmitter.
2. If no sound can be heard on the output device:
· Make sure the volume of the output device is set correctly.
· Make sure that the HDMI cables used are plugged into the sockets correctly.
· The connection may not be functioning correctly due to HDCP. Restart the receiver and transmitter by
disconnecting both from the power supply and then reconnecting them.
FALCON HD
9