Digital Projection E-Vision 4500 Serie Manual De Instrucciones página 5

Digital Projection
E-Vision 4500 Series
Installation precautions
The projector must be installed only by suitably qualified personnel, in accordance with
local building codes.
The lamp and colour wheel must be changed only by suitably qualified personnel.
The projector should be installed as close to the power outlet as possible.
The power connection should be easily accessible, so that it can be disconnected in an
emergency.
Ensure that there is at least 50cm (20in) of space between the ventilation outlets and
any wall, and 10cm (4in) on all other sides.
If ceiling mounting, ensure there is 30cm (12in) of space between the projector and
ceiling.
Do not install the projector close to anything that might be affected by its operational
heat, for instance, polystyrene ceiling tiles, curtains etc.
The projector is heavy. Use safe handling techniques when lifting the projector.
Before installation, make sure that the surface, ceiling or rigging that is to support the
projector is capable of supporting the combined weight of the projector and lens.
Backup safety chains or wires should always be used with ceiling mount installations.
Do not place heavy objects on top of the projector chassis.
Do not stack the projectors.
Do not drop or knock the projector.
Place the projector in a dry area away from sources of dust, moisture, steam, smoke,
sunlight or heat.
Do not tilt the projector from side to side when in use, as this may cause serious lamp
failure, damage the lamp module and cause extra cost on replacement.
Desktop
±0°
±0°
Ceiling
Rev B August 2014
±15°
Standard Lamp
±15°
Tilt Lamp
Important Information
±15°
±15°
Page 5