Publicidad
Installation of the filter system
Step 1: Fix the filter head and the filter
1. Paste the assistant label to finish drilling. (Note: Mount the water filter at least 2 inches
higher than the ground for easier filter change.)
2. Install the screw and reserve enough space to hang the filter.
3. Hang the filter system on the screw.
Step 2: Connect the water supply (cold water only)
1. Connect the inlet hose and the outlet hose to the filter head. (Figure 1)
Note: When the hose is tightly inserted, there will be a 1/8 inch gap between the hose and the filter head, which
is designed for easy replacement and won't affect the sealing performance.
2. Shut off the water supply. Remove the faucet hose. (Figure 2)
Figure 1
Inlet hose
outlet hose
3. Connect the inlet hose to the cold water valve.
• If the angle valve outlet is 3/8", it can be directly connected to the water supply . (Figure 3)
• If the angle valve outlet is 1/2", connect it with a No.1 converter at first. (Figure 4)
Figure 3
3/8" outlet
Step 3: Connect to the faucet
1. If the faucet hose is 3/8", it can be directly connected to the outlet hose. (Figure 5)
2. If the faucet hose is 1/2", connect it with a No.2 converter at first. (Figure 6)
Figure 2
Figure 4
①
1/2" outlet
Connect ① to the cold angle valve
Figure 5
Faucet hose
Outlet hose
Note: If a female threaded connector is needed, please contact our service team for help.
Check the leaks and flush the filter
1. If water leakage occurs, turn off the water supply. If the water leakage is occurring at position 1 and 2, wrap
Teflon tape on the external thread. If the water leakage is occurring at position 3 or 4, insert the quick-connect
fitting to the end and make sure the hoses hit the bottom of the fitting.
2. Flush the filter for 5 minutes before use.
To disconnect
Use your thumb and index finger to press down on the
lock sleeve. Use your other hand to pull out the hose
from the fitting.
Note: Please do not pull out the tubing directly, or else
it will damage the fitting and cause leakage.
Filter replacement
1. It's recommended to turn off the water supply and turn
on the faucet to release the water pressure.
2. Rotate 1/4 turn to the left to remove the filter.
3. Take out the new filter and remove the protective cap.
4. Rotate 1/4 turn to the right to install the filter. Ensure
that the filter's triangle mark is aligned with the connec-
tion mark.
5. Turn on the cold water valve and flush for 5 minutes.
Figure 6
Faucet hose
②
Faucet hose
1
Inlet hose
2
3
4
Outlet hose
Hot
Cold
Filter system
Press
Press
Remove the filter
Install the filter
Pull
Publicidad
