Publicidad
Idiomas disponibles
Idiomas disponibles
operation.
●Operate the reversing switch only after the tool
comes to a complete stop. Changing the direction
of rotation before the tool stops may damage the
tool.
●When not operating the tool, always set the
reversing switch lever to the center position.
●Never force to pull the switch trigger while the
reversing switch lever is set at the center position.
■Right/Clockwise Rotation
Depress the reversing switch lever from side B to
side A for clockwise rotation for drilling and driving
in screws (view forwards).
■Left/Counterclockwise Rotation
Depress the reversing switch lever from side A to
side B for counterclockwise rotation for loosening
or unscrewing screws.
B
A
1
Installing or Removing Tools
The tool here includes driver bit, drill bit, etc, which
differs from the concept of power tools or machines.
CAUTION:
●Before operation, the reversing lever must be
centrally positioned and the battery pack removed.
Never press the switch button.
●After loading the tool, pull and push the tool by hand
along the direction of the arrow to make sure the tool
is fixed to the machine.
To install the bit, pull the locking cover along the
arrowdirection and insert the bit to the inner most of
thesleeve, then loosen the sleeve to fix the bit.
1
To remove the bit, pull the locking cover and pull out
the bit along the arrow direction.
1.Reversing Switch
Lever
2
2.Counter clockwise
3.Clockwise
3
1.Locking Cover
2.Tool
2
1
Tightening and Moving Screw
CAUTION:
●When tightening or removing screws(nuts), the
power tool should be turned off before placing the tool
on the screws(nuts). If the tool does not stop, continue
to turn, the sleeve can easily slip away from the nut or
bolt head.
●Make sure the dirver bit is inserted vertically into the
screw head, otherwise the screw head or batch head
may be damaged.
Tightening the Screw
Put the Point of driver bit on the screw head and apply
appropriate pressure to the machine, slowly start the
machine, then gradually increase the speed. Release
the switch button as soon as the screw hits the bottom.
1
2
Moving the Screw
CAUTION:
When removing the screw, the positive and negative
turning slider is in the reverse position. Make sure
the batch head is inserted vertically into the screw
head, otherwise the screw head or batch head may be
damaged.
Place the tip of th driver bit on the screw head and
apply appropriate pressure to the machine. Start the
machine slowly, then gradually provide revs.Release
the switch button as soon as the screw is removed.
1
2
Work Light
The white LED work light will be lit after pulling the
switch trigger for illumination of the work area under
unfavorable lighting conditions.
1.Locking Cover
2.Tool
2
1.Point of driver bit
2.Screw Head
1.Point of driver bit
2.Screw Head
EN
11
Publicidad
