MILK-BASED BEVERAGE
PROGRAMMING THE COFFEE/GALÃO - LATTE AMOUNT
When in Ready to Use Mode, the milk tank with enough milk is connected to the milk system.
Adjust the selector to the Galão - Latte position.
Button D and selector's side light is green.
Raise the lever to its full extent and insert a Delta Q coffee capsule
in the capsule housing hole, in accordance with the housing
silhouette. Completely lower the lever.
Place a glass of Galão - Latte under the extraction nozzle.
Hold the button D more than 3 seconds, and the button A, B and C
blink.
Press the button D again, thus beginning the coffee extraction.
When the coffee reaches the desired amount, press the button D.
The machine memorises this coffee volume and will start extracting
it until a new programme is set.
Afterwards, the machine pre-heats (approximately 25 seconds).
When it reaches the right temperature, the milk extraction begins
and when the milk reaches the desired amount, press the button D
again. And it return to Ready to Use Mode.
The machine memorises this milk volume and will start extracting it
until a new programme is set.
If no button is pressed for 1 minute, the machine will return to Ready to Use Mode and will
memorise the last volume set.
If button D is not pressed to stop the extraction process, the machine will automatically
stop when it reaches approximately 220cc.
PROGRAMMING THE COFFEE/CAPPUCCINO AMOUNT
When in Ready to Use Mode, the milk tank with enough milk is connected to the milk system.
Adjust the selector to the Cappuccino position.
Button D and selector's side light is green.
The next steps are the same as for predefining a Galão - Latte.
The difference is the cappuccino starting as follows: first the milk
foam (the machine pre-heats for approximately 25 seconds. when it
reaches the right temperature, the milk foam extraction begins) and
then the coffee.
If button D is not pressed to stop the extraction process, the machine will automatically
stop when it reaches approximately 220cc.
— 11 —
EN
A
B
C
A
B
C