Publicidad
Idiomas disponibles
Idiomas disponibles
14. After each starting attempt, where engine fails to run,
always point gun in safe direction, press red button and
squeeze spray gun trigger to release high pressure.
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• ALWAYS point spray gun in safe direction, press red button
and squeeze spray gun trigger, to release high pressure, every
time you stop engine.
NOTE: Always keep the throttle lever in the "Fast" position
when operating the pressure washer.
How to Stop Your Pressure Washer
1.
Release spray gun trigger and let engine idle for two
minutes.
2.
Move throttle to SLOW position, then STOP position.
3.
ALWAYS point spray gun in a safe direction, push red
button and squeeze spray gun trigger to release retained
high water pressure.
IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places to
store your spray gun, nozzle extension and quick connect
PrecisionSpray™ nozzles. There is also a detachable hose
wrap at the back of the accessory tray to hold your high
pressure hose.
1.
Place nozzle extension in clip on back of accessory tray.
2.
Place spray gun through hole on accessory tray on right
side of unit.
3.
Insert multi–colored nozzles in spaces provided in
accessory tray.
4.
Wrap high pressure hose on hose wrap then attach hose
wrap to back of accessory tray.
5.
Hook provided on back of accessory tray for safely
storing safety goggles.
How to Use PrecisionSpray™ Nozzle System
The quick–connect on the nozzle extension allows you to
switch between five different PrecisionSpray™ system
nozzles. PrecisionSpray™ nozzles can be changed while
pressure washer is running once spray gun trigger lock is
engaged.
Follow these instructions to change PrecisionSpray™
nozzles:
1.
Pull back collar on quick–connect and pull current
PrecisionSpray™ nozzle off. Store PrecisionSpray™
nozzles in holder provided on the accessory tray.
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER exchange nozzles without the trigger locked on the
spray gun.
• DO NOT twist nozzles while spraying.
2.
Select desired PrecisionSpray™ nozzle:
•
Select orange general PrecisionSpray™ nozzle for all
purpose cleaning. Cleans vinyl siding, brick patios,
concrete driveways and other surfaces.
•
Select red max PrecisionSpray™ nozzle for maximum
cleaning. Great for cleaning stubborn stains, including
grease, tar, wax, and other hard to remove stains.
•
Select cyan jet flush PrecisionSpray™ nozzle for
quick high flow clean up and long reach cleaning of
second story siding and windows.
13
WARNING
Publicidad
