Descargar Imprimir esta página

Craftsman 580.752280 Manual Del Operador página 8

Ocultar thumbs Ver también para 580.752280:

Publicidad

Idiomas disponibles

Idiomas disponibles

5.
Attach rope guide (A) through handle with plastic knob
(B). Tighten by hand. Route engine recoil rope through
guide.
A
6.
Align hose wrap (C) to the back side of accessory tray.
Locate notch with "unlock" icon (D) on hose wrap.
Position notch at top with hose wrap in vertical position.
Clips in the back of accessory tray should slide into the
grooves on the inside surface of hose wrap. Slide hose
wrap on back of accessory tray and rotate 1/8 turn until
"locked" icon (E) is in vertical position. Hose wrap is
easily removed from the accessory tray for wrapping and
unwrapping of the high pressure hose. A clip to secure
the hose on the reel makes it easy to wrap the hose
while it is detached from the accessory tray.
D
C
7.
Attach battery (F) to handle with carriage bolt (G) and
black plastic knob (H). Tighten by hand.
F
H
8.
Attach battery lead (J) to the similar connection under
the fuel tank. Press the ends tightly together by hand.
NOTE: If your battery is discharged, charge prior to use
following the instructions in the section Battery Float Charger.
B
E
G
J
9.
Attach bottle bracket (K) to handle with carriage bolt (L)
and black plastic knob (M). Tighten by hand.
K
2-IN-1 SIPHON SYSTEM
The pressure washer is equipped with two detergent
siphoning hoses.
Standard Clear Siphon Tube
Clear tube with filter:
When using the clear siphon tube, dilute
1 part concentrate to 16 parts water
(4 oz of standard concentrate makes
1/2 gallon of mix.)
Project Pro
®
Blue tube with blue bottle cap:
When using the blue PerfectMix
use the concentrate straight from the bottle
(One quart bottle of Perfect Mix
makes 4.25 gallons of soap spray.)
Attach P P r r o o j j e e c c t t P P r r o o
® ®
Attach the hose end of the blue Project Pro
Siphon (N) to the barbed hose fitting (P) on the pump.
Attach PerfectMix
TM
to Concentrate Bottle
Place Project Pro
®
PerfectMix
wire-form bracket on the handle. Remove cap from bottle
and insert the Project Pro
the siphon unit to the top of the bottle (R). Use the clip on
the cap (Q) to snap siphon to wire form bracket when siphon
is not in a concentrate bottle.
R
8
L
M
PerfectMix
TM
Siphon
siphon,
TM
TM
concentrate
P P e e r r f f e e c c t t M M i i x x
S S i i p p h h o o n n to Pump
T T M M
®
PerfectMix
N
P
Detergent Siphon
bottle (not included) in the
TM
PerfectMix
Siphon (Q). Screw
®
TM
Q
TM

Publicidad

loading