DeWalt DCR006 Manual De Instrucciones página 13

PAIRING SPEAKER WITH A BLUETOOTH
(FIG. 6, 7)
1. Place the speaker and the Bluetooth
(1 m) of each other.
2. Turn speaker on by pressing the power button (A). The LED (B)
will light solid for 4 seconds to indicate the apparatus powered on
successfully and then go into a half second interval blink pattern.
®
3. Press the Bluetooth pairing button (C). The LED indicator light
blinks rapidly indicating the speaker is in pairing mode and is
discoverable by your Bluetooth
4. Confirm pairing on your device. (Please consult your device's
instruction manual for specific pairing instructions.)
NOTE: If pairing is not confimed within 2 minutes, the LED will
stop flashing and the speaker will return to half second interval
blink pattern.
5. Once pairing is successful the LED indicator (B) will turn solid
and the speaker will emit a short tone. The speaker will now play
music from your device.
CONNECTING A PREVIOUSLY PAIRED BLUETOOTH
DEVICE (FIG. 1, 7)
®
If a Bluetooth device has been previously paired to the speaker
it should automatically reconnect when speaker is powered on.
After 4 seconds the speaker will go into connecting mode. This is
indicated by the LED (B) blinking steady. Once the previously paired
®
Bluetooth device is recognized and connected, the LED will go
solid. If connection does not occur and you are unable to stream
music please follow the instructions for Pairing Speaker with a
®
Bluetooth Audio Device.
Page dimensions: 8.5 x 5.5 inches
® AUDIO DEVICE
®
audio source within 3.3'
® device.
® AUDIO
ADJUSTING THE SPEAKER VOLUME (FIG. 7)
The speaker volume can be decreased or increased by using the
corresponding volume buttons (E). Pressing the "VOL +" button
increases the volume. Pressing the "VOL -" decreases the volume.
The pause button (D) can silence the speaker at any volume by being
pressed once. Pressing the pause button again will unpause the
speaker. The speaker will emit a tone when the maximum or minimum
volume is reached.
TIMEOUT FUNCTIONALITY (FIG. 1)
To conserve battery life the speaker is designed to power off
automatically after an hour of inactivity. This inactivity could be due to
the device being unpaired for an hour or in the case of the Bluetooth
connection being broken for the same period of time. If the speaker
powers off due to inactivity of any kind refer to Connecting a
Previously Paired Bluetooth
NOTE: Optimum Bluetooth
(9 m) (line of sight) to the speaker but distances up to 100 feet
(30 m) are possible. Physical obstacles, other wireless devices or
electromagnetic devices may affect the connection quality.
If Bluetooth ® connection is lost due to exceeding time of separation,
exceeding the optimum distance, obstacles or otherwise, reconnecting
your device with the speaker may be necessary.
CHARGING A CELL PHONE OR AUDIO DEVICE VIA USB
(FIG. 1)
Your audio device or mobile phone can be charged using the USB
power port (G) on the speaker. This charging is possible when unit is
on, running off of AC plug power or the battery pack.
11
®
Audio Device.
® streaming range is roughly 30 ft
®