Alsafix D 38/100 P1 Manual De Operaciones página 14

1. DO NOT FIRE THE TOOL WHEN IT IS EMPTY
2. USE A 3-PIECE AIRSET
Failure to use a 3-piece airset allows the moisture and dirt inside compressor to pass into the tool
directly. This cause rust and wear, and results in a poor operating performance. The hose length bet-
ween airset and tool should be no longer than 5 m since a longer lenth results in a reduction in air pres-
sure.
3. USE RECOMMENDED OIL
The velocite or turbine oil should be used to lubricate the tool. Upon completion of operations, place 2
or 3 drops of oil into the aire plug inlet with the jet oiler.
4. INSPECT AND MAINTAIN DAILY OR BEFORE OPERATION
Disconnect air supply and empty the magazine when inspecting or maintaining the tool.
Drain air line filter and compressor
Keep lubricator filled in air 3-pieces set
Clean filter element of air 3-pieces set
Tighten all screws
Keep contact arm moving smoothly
1. When not in use for an extended period, apply a thin coat of the lubricant to the steel parts to avoid
rust.
2. Do not store the tool in a cold weather environment. Keep the tool in a warm area.
3. When not in use, the tool should be stored in a warm and dry place. Keep out of reach of children.
4. All quality tools will eventually require sevicing or replacement of parts because of wear from the nor-
mal use.
The troubleshooting and/or repairs shall be carried out only by the ALSAFIX SAS authorised distribu-
tors or by other specialists.
MAINTAIN FOR PERFORMANCE
STORING
TROUBLESHOOTING/REPAIRS
14