STEINEL LS 150 S Manual Del Usuario página 16

Important note: the control gear cannot be
replaced.
9. Troubleshooting
Unit without power.
– Fuse not switched ON or faulty.
• Switch ON fuse.
• Change faulty fuse.
– Break in wiring.
• Switch ON mains switch.
• Check wiring with voltage tester.
– Short circuit in mains power supply lead.
• Check connections.
Unit does not switch ON.
– Wrong twilight setting selected.
• Re-set brightness response threshold
– Mains switch OFF.
• Switch ON mains switch.
– Fuse not switched ON or faulty.
• Switch ON fuse.
• Change faulty fuse.
– Detection zone too small or incorrect.
• Check and adjust detection zone.
– Light source faulty.
• The light source cannot be changed. Com-
pletely replace unit.
Unit does not switch OFF.
– Continued movement within the detection zone.
• Check detection zone.
• If necessary, limit or change detection zone.
Unit switches ON when it should not
– Movement within the detection zone, e.g. from
animals, trees or cars.
• Check detection zone.
• If necessary, limit or change detection zone.
– Unit is moving as a result of gusts of wind or
precipitation.
• Mount unit on a firm surface.
10. Disposal
Electrical and electronic equipment, accessories
and packaging must be recycled in an environmen-
tally compatible manner.
Do not dispose of electrical and elec-
tronic equipment as domestic waste!
EU countries only:
Under the current European Directive on Waste
Electrical and Electronic Equipment and its imple-
mentation in national law, electrical and electronic
equipment no longer suitable for use must be
collected separately and recycled in an environ-
mentally compatible manner.
11. Declaration of Conformity
STEINEL GmbH hereby declares that the LS 150 S /
LS 150 conforms to Directive 2014/53/EU.
The full wording of the EU Declaration of Conformity
is available for downloading from the following Inter-
net address: www.steinel.de
12. Manufacturer's warranty
Manufacturer's warranty of STEINEL GmbH,
Diesel strasse 80-84, DE-33442 Herzebrock-Clarholz,
Germany
All STEINEL products meet the highest quality
standards. For this reason, we, the manufacturer,
are pleased to provide you, the consumer, with a
warranty under the following terms and conditions:
The warranty covers the absence of deficiencies
which are proven to be the result of a material
defect or fault in manufacturing and which are re-
ported to us immediately after detection and within
the warranty period. The warranty shall apply to
all STEINEL products sold and used in Germany –
excluding STEINEL Professional products.
You can opt for warranty cover in the form of
repair or replacement which will be provided free
of charge (if applicable, in the form of a successor
model of the same or higher quality) or in the form
of a credit note.
The warranty period for the STEINEL product you
have purchased is 3 years (5 years for products
from the XLED home range) in each case from the
date on which the product was purchased.
We shall bear the shipping costs but not the trans-
port risks involved in return shipment.
Statutory rights accruing from defects, gratui-
tousness
The warranty cover described here shall be
applicable in addition to the statutory rights of
warranty – including special consumer protection
provisions – and shall not restrict or replace them.
Exercising your statutory rights in the event of
defects is gratuitous.
– 16 –