Instructions - Easy Home TC16 Manual Del Usuario

Heated Blanket

INSTRUCTIONS

Using Your Blanket Digital Controller ( Model# TC16 )
The very first time the blanket is plugged in and turned ON, the display on the
controller should read " 4 ". If the display does not illuminate or reads "E", see the
Trouble shooting section.
Turning the Blanket "On"
Once the cords are correctly plugged in, press the ON / OFF button. The LED display will
light up to show that the power is ON. NOTE: If you have a Queen or King sized product,
you will need to connect both controllers to heat both sides of the product; each control-
ler will only heat one side.
Adjusting the temperature
To adjust the temperature setting, press one of the arrow buttons. Press the UP arrow to
increase the heat setting and the DOWN arrow to decrease it. There are 10 heat settings,
1 through 9 and "H" for HIGH, the higher the number, the warmer the product. Each time
you press an arrow button the setting will adjust by one digit. If you have a product that
uses two controllers, each controller can be adjusted to different settings, causing each
side to heat differently.
Turning "OFF"
Turn the controller OFF manually by pressing the ON / OFF button. When the controller
is OFF but plugged in, you will see a red or green light on the controller without the
number displayed. Seeing this light alone means the controller is in standby mode and
the bedding is off and not heating. Turn OFF or unplug the controller when not in use.
Pre-Heat ( Specific Models Only )
Press the PRE-HEAT button. This will start pre-heating the bedding and "p" will be
displayed on the controller. The heat setting will change to the last setting after
1.5 hours. If you want to change to another setting during the pre-heat period,
press the UP or DOWN button.
After Sales Support
800.789.6441
Instructions
cs1@biddefordblankets.com
7