Publicidad
Idiomas disponibles
Idiomas disponibles
Sliding Hammer Blind Hole Puller, 10 - 32 mm
INTENDED USE
This tool set allows a dismantling of bearings and sleeves out of blind holes. By using the spreading claws
witch are listed in table the set is suitable for many bearings and sleeves. This set is suitable for cars,
motorcycles, agricultural machinery and other machinery.
TOOLS
Sliding Hammer, weight: 1430g, length: 370 mm
Spreading claw for bearing inner diameter 10-14 mm
Spreading claw for bearing inner diameter 15-19 mm
Spreading claw for bearing inner diameter 18-25 mm
Spreading claw for bearing inner diameter 25-32 mm
SAFETY ADVICE
•
Check all components of the tool and replace any damaged parts, do not use the tool if any parts are
damaged.
•
Use this tool only for work for which it is designed. An improper use will invalidate the warranty and
may cause injury.
•
Attach the slide hammer always by using the complete pitch of screw thread, an adaptation with only
a few pitch of screw thread can lead to damage the thread and personal injury.
•
Always wear safety googles and gloves when using this tool.
INSTRUCTION
Chose a suitable spreading claw (4). The size
has to be chosen in accordance to the internal
diameter of the bearing to be pulled (5).
Push the spreading claw (4) through the inner
ring of the bearing so that the pulling edge of the
spreading claw grabs behind the inner ring of the
bearing (5).
Tightening the spreading screw (3) to adjust the
diameter of the spreading claw to the internal
diameter inner ring of the bearing.
Mount slide hammer (1) onto the adaptor screw
(2).
Operating the sliding hammer carefully and pull
the bearing out of the housing (6).
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
6
e
s
s
a r t S
h
c
s
m
e
R
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
8598
L
d . l h
a t s
w
s
@
o f n i
: l i
Publicidad
