Makita HM1802 Manual De Instrucciones página 5

1
► 1. Triangle alignment mark
Set the triangle alignment marks on the hammer body
and on the soft grip when installing the soft grip.
Installing or removing the bit
(optional accessory)
CAUTION:
• Always assure that the bit is securely retained by attempt-
ing to pull the bit out of the tool holder after installing the bit.
• Follow the below 2 installation methods in accordance
with the 2 different types of bits. If inappropriate instal-
lation method is selected, the bit cannot be secured.
1
► 1. Bit with collar 2. Bit without collar
This tool accepts bits either with or without a collar on its shank.
To install the bit, follow either procedure (1) or (2) described below.
(1) For bits with a collar
1
2
► 1. Bit 2. Tool retainer 3. Tool holder
Pivot the tool retainer downward (approx. 60 degrees).
Insert the bit into the tool holder until it stops. Return the
tool retainer and secure the bit.
(2) For bits without a collar
► 1. Notched portion of the bit 2. Tool retainer 3. Tool holder
Pivot the tool retainer upward (approx. 60 degrees). Face the notched
portion of the bit upward. Insert the bit into the tool holder until it
stops. Pivot the tool retainer further until it stops at the tool holder.
To remove the bit, follow the installation procedure in reverse.
OPERATION
Chipping/Scaling/Demolition
•
2
•
•
•
•
3
Always use the soft grip (auxiliary handle) and firmly
hold the tool by both side grip and switch handle during
operations.
5 ENGLISH
2
1
CAUTION:
Keep well-balanced posture when holding the
heavy tool before / during / after operation to
avoid personal injuries.
Secure debris in case of breaking it into smaller pieces.
Hold the tool firmly with both hands. Turn the tool on
and apply slight pressure on the tool so that the tool
will not bounce around, uncontrolled. Pressing very
hard on the tool will not increase the efficiency.
Do not pull out the tool if stuck. Instead, break
the work around the bit tip.
Be sure to place the tool on the stable floor or
ground after use.
3