Publicidad
Idiomas disponibles
Idiomas disponibles
EnGLIsh
j. To reduce the risk of explosion, electric shock and
property damage, never cut gas lines, electrical lines,
or full water lines. Shut off water and drain lines before
making a cut.
Storage Recommendations
The best storage place is one that is cool and dry, away from
direct sunlight and excess heat or cold.
Package Contents
The package contains:
1 PVC/PEX cutter
1 Instruction manual
•
Check for damage to the tool, parts or accessories which may
have occurred during transport.
•
Take the time to thoroughly read and understand this manual
prior to operation.
Markings on Tool
The following pictograms are shown on the tool:
a
Read instruction manual before use.
g
Wear ear protection.
f
Wear eye protection
Laceration hazard
Date Code Position (Fig. A)
The production date code
11
by a 2-digit week and is extended by a 2-digit factory code.
Description (Fig. A)
WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Back knob
1
Brace bracket
2
Arm knobs
3
Attachment shank
4
Arm joint
5
Arm slider
6
Bar
7
Bar channel
8
Slide lock
9
Blade
10
Blade cover/alignment guide
11
Front slot
12
Hook
13
Tabs
14
Arrow
15
Plug
16
Date code
17
20
consists of a 4-digit year followed
Intended Use
This PVC/PEX cutter is designed for professional cutting of the
following PVC and PEX materials.
Max pipe diameter: 2.4" (60.3 mm)
-
-
Materials to be cut: PVC, uPVC, cPVC and PEX Types A, B,
and C
DO nOT use under wet conditions or in the presence of
flammable liquids or gases.
This impact wrench is a professional power tool.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
This product is not intended for pruning activities or cutting
any cables.
.Young children and the infirm. This appliance is not intended
for use by young children or infirm persons without supervision.
•
This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with this product.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
WARNING: Never modify this device or any part of it.
Damage or personal injury could result.
Attach the Universal Brace Bracket
(Fig. B ‑ D)
1. Remove battery from Impact Driver. Do not reinstall
battery until aFTER the Brace Bracket is installed.
2. Loosen the back knob
1
wide enough to slip the Impact Driver through (as shown in
Fig. B).
3. Slide the Impact Driver into the Brace Bracket from the top (as
shown in Fig. C).
4. Place the Impact Driver and Brace Bracket on a FLaT surface.
5. Compress the front end together until the Brace Bracket is
snug around the Impact Driver foot, then tighten the back
knob. Both sides should remain parallel during tightening
(as shown in Fig. D).
Attach the Brace Arm and Impact Connect
Attachment (Fig. E ‑ G)
1. The blade should be fully advanced with the blade cover
installed as the initial step.
2. Loosen both yellow arm knobs
attachment shank
4
into the impact driver chuck
shown in Fig. E).
until the Brace Bracket
2
can open
3
one turn and insert the
18
(as
Publicidad
