Publicidad
Idiomas disponibles
Idiomas disponibles
EnGLIsh
Cutting PVC/PEX (Fig.K)
1. Mark the cutting point on the pipe.
2. Secure pipe to prevent it from moving while cutting.
3. Insert the pipe into the "V" notch for optimal cutting.
4. Align the blade with mark.
5. Depress the trigger of the impact driver.
6. After the tubing is fully cut, release the trigger .
7. Retract blade fully into housing for subsequent cut, storage,
or transportation.
MAINTENANCE
Your power tool has been designed to operate over a long
period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
The charger and battery pack are not serviceable.
D
Cleaning
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories
WARNING: Since accessories, other than those offered
by D
WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
22
WALT-recommended
e
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
w
household waste.
Products and batteries contain materials that can be
recovered or recycled, reducing the demand for raw materials.
Please recycle electrical products and batteries according to local
provisions. Further information is available at www.2helpU.com.
Rechargeable Battery Pack
This long-life battery pack must be recharged when it fails to produce
sufficient power on jobs that were easily done before. At the end of
its technical life, discard it with due care for our environment:
•
Run the battery pack down completely, then remove it from
the tool.
•
Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
Publicidad
