Makita 1806B Manual De Instrucciones página 4

Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Adjusting depth of cut
► 1. Knob
Depth of cut may be adjusted by simply turning the knob
on the front of the tool.
Switch action
► 1. Lock button 2. Switch trigger
•
•
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Foot
1
► 1. Planer blade 2. Rear base 3. Foot
After a cutting operation, raise the back side of the tool
and a foot comes under the level of the rear base. This
prevents the tool blades from being damaged.
4 ENGLISH
CAUTION:
Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
Switch can be locked in "ON" position for ease
of operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
3
2
1
2
1