Genie LA 300 A4 Instrucciones De Funcionamiento página 7

(GB) Operating Instruction
Dear customer,
the operating manual represents a component part of the device. It contains
important information regarding safety, use and disposal. Familiarize yourself with all
the operating and safety information before starting to use the device. Only use the
device as described and for the purpose for which it is intended. Hand over all the
documents with the device if it is transferred to third parties.
Intended Use
The laminator is only suitable for laminating documents. Any other use or
modification shall be deemed to be improper and involves substantial risk of
accidents.
Important advice about safety
1. Read through these operating instructions carefully and completely before using
the machine for the first time.
2. Only put the machine on a flat and dry surface. It must be freely accessible from
all sides. It is not recommended to use an extension cable!
3. Do not open or repair the laminating machine yourself but take it to your
specialized dealer whenever it is damaged, or contact our service hotline.
4. Only use films of the correct size (up to DIN A4 max.) and thickness (80 to 125
microns). Films that are too thin cause a blockage of the film in the machine.
5. Do not touch the hot surface of the machine after it has started up.
6. The laminating machine is not allowed – for safety reasons – to be used by
children, unless they are supervised by an adult.
7. Never use the machine outdoor or near water.
8. Hot lamination: do not laminate in this mode any materials that are sensitive to
heat with this machine, like thermo-fax paper for example. These materials are
only suitable for cold lamination.
9. Do not pour or spill any liquid into the machine or onto it.
10. Do not insert any metal objects into the machine. Please do not grasp inside the
machine with your fingers.
11. The laminating machine is unsuitable for constant use commercially. It is
recommended to switch off „O" the machine for 30 minutes, after it has been
operating for a period of approximately 120 minutes.
12. The socket should be near the device and easily accessible.
7