Publicidad
Idiomas disponibles
Idiomas disponibles
Low Battery
This scale is equipped with a low battery indicator. Replace the batteries when "Lo" is
displayed or readings grow dim or become irregular.
Battery Replacement
1. Use 4 AA batteries only.
2. Open battery compartment on bottom of unit by pushing tab in direction of "open"
arrow and lifting up hinged lip.
3. Remove old batteries from compartment.
4. When installing batteries, observe proper +/- polarities as marked inside the battery
compartment. Incorrect battery installation may cause damage to the unit. Do
not mix different types of batteries together (e.g. alkaline with carbon-zinc or old
batteries with new).
5. Close the battery cover. Be sure it clicks shut.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc)
batteries.
• Clean the battery contacts and also those of the device prior to battery
installation.
• Remove used batteries promptly.
• If the unit is not going to be used for a long period of time, remove batteries to
prevent damage due to possible battery leakage.
NOTE: Please recycle or dispose of batteries per local regulations.
WARNING: Batteries may pose a choking hazard. Do not let children handle
batteries.
Trouble Shooting
In Case of Difficulty...
1. Move scale to a location where it will not be bumped. If scale is bumped while being
activated or while in use, an inaccurate reading may occur. Initialize the scale as
described in First Time Setup #4.
2. Make sure the batteries are properly installed.
Note: Special Displays
Weight Mode: Unstable weight, begin again
Weight over load; remove weight immediately
Lo
Low battery; Replace batteries
BATTERY PRECAUTIONS
6
Publicidad
