Style selections LWSGDS Instrucciones De Ensamblaje página 4

ASSEMBLY INSTRUCTIONS
4. Insert the wood dowels (CC) into the holes pre-drilled
on bottom edge of assembled frame. Position the bottom
panel (F) onto the inserted dowels and attach in place by
engaging M4 x 50 mm screws (DD) as shown figure.
Hardware Used
CC
Wood dowel
M4 x 50 mm
DD
Screw
5. Expand the back panel (G) and lay it onto the back
edges of assembled frame making sure the margins
along all edges are equal. Attach the back panel in
place by using M3.5 x 15 mm screws (FF) through the
pre-drilled holes of back panel.
Hardware Used
FF M3.5 x 15 mm Screw
6. Attach a handle (KK) to the front side of door (H) us-
ing the 5/32" x 25 mm bolts (JJ) provided. Extend the door
hinges (LL) and rest the hinge cups onto the cutouts of
door (H). Hinges in place by using M4 x 15 mm screws
(MM) in each. As shown in figure.
Hardware Used
JJ 5/32" x 25 mm Bolt
KK
Handle
LL Door hinge
MM M4 x 15 mm Screw
4
C
D
CC
x 4
x 4
5
G
x 20
6
MM
LL
JJ
x 4
H
x 2
x 4
KK
x 8
7
ASSEMBLY INSTRUCTIONS
7. Pick up both doors (H) and fasten the hinge bases
onto the side panels with the M4 x 15 mm screws (MM).
DO NOT fully tighten the screws. Close the doors to double
check the alignment. If you find that the doors need to be
adjusted slightly, please refer to the supplement on page
#3 and turn the appropriate screws for a perfectly aligned
door. After adjusted, tighten the screws on the hinge base
to lock the hinges in place.
F
Hardware Used
MM M4 x 15 mm Screw
DD
If you plan to use this unit as hutch (stand this on another
one), please skip step 8.
FF
8. Insert floor levelers (GG) into the bottom of bottom
panel (F).
Hardware Used
GG Floor Leveler
9. Insert the caps (HH) into the holes on top of the top
panel (A).
Hardware Used
HH
Cap
x 2
7
H
x 16
H
8
x 4
GG
9
x 4
HH
8
MM
F
A