Adjusting The Harness - Echo PB-265ESLT Manual De Instrucciones

Caution at the time of fitting the handle
1. Collar
1. Side having the notch
3. Protrusion

Adjusting the harness

1. Buckle
2. Handle
2. Protrusion
Before you start
The collar is used one piece each right and left between the
handle and blower pipe.
The collar is being installed with the handle at the time of ship-
ping.
Do not operate in the condition of the collar being taken off.
In case of the collar being taken off or in case of changing the
collar, install it in the following procedures.
1. Confirm the top and bottom of the collar. If assembled in op-
position, the handle is not fixed.
2. The side having the notch is positioned on the upper side
(throttle lever side).
3. Hang the two places of the protrusion to the handle.
4. Press in the opposite side and fix the collar.
To tighten straps
Pull strap loops down.
To loosen straps
Pull the buckle up and pull the straps down.
15