Filling chemical tank and control lever position
Adjusting discharge volume
Metering Rod Setting Positions, Type of Chemicals, Spray Methods
Metering Rod Setting Position
MAX Position
Position 3
Position 1
Granule :Diameter
φ3-5
Control lever Position
Operating duster
Operating duster
1.
Close shutter assembly by setting control lever (A) down to
bottom position.
2.
Fill tank with chemicals.
3.
Secure tank cap firmly to avoid chemical leakage.
4.
Make sure that shutter assembly is closed.
Be sure that shutter control lever is in the bottom position
before starting the engine.
Type of Chemical, Spray Method
Dust/DL Dust Hose Spraying
Fertilizer Spraying
3 Kilo Granule Spraying
Dust/DL Dust Spray Tube Spraying
1 Kilo Granule Spraying
As an example, please refer following chart to a relation of con-
trol lever opening (position) and discharge rate at the condition
of setting metering rod "3" position.
Please adjust metering rod setting position according to the
type of pesticide used.
5
NOTE