Publicidad
Idiomas disponibles
Idiomas disponibles
Locating a Circuit Breaker or Fuse using the TL-532A Alligator Clip
Lead Set
Arc Flash and Shock Hazard, Proper PPE Required. Follow all safety procedures,
wear proper PPE in accordance to NFPA 70E. Read and fully understand the
instructions below prior to using this product. Failure to comply can result in
serious injury or death.
WARNING
Shock Hazard, wear proper PPE in accordance to NFPA 70E. Do not touch the
metal alligator clips on the TL-532A Lead set when attaching to live conductors.
Keep your fingers on the protective hood. Failure to comply can result in serious
injury or death.
1. Insert the 61-532 transmitter prongs into the plug at the end of the TL-532A
Lead Set.
2. Carefully attach the black alligator clip to the white (Neutral) conductor, making
sure your fingers stay on the protective hood of the alligator clip. DO NOT
TOUCH THE METAL ALLIGATOR CLIP!
3 Carefully attach the red alligator clip to the black (Hot) conductor, making sure
your fingers stay on the protective hood of the alligator clip. DO NOT TOUCH
THE METAL ALLIGATOR CLIP!
4. The illuminated LEDs at the end of the transmitter will verify the presence
of power.
Note: The OPEN GROUND LED Indication is normal in this situation.
5. Follow the procedure described in Locating a Circuit Breaker or Fuse,
steps 3 through 7.
12
WARNING
Publicidad
