Loading paper into the printer
To load paper into the printer:
1. Open the paper container
by carefully lifting the
printer door on the front of
the printer.
2. Insert a new roll of paper
and allow one or two
centimeters of paper to
extend above the printer
surface. paper should
be inserted so the paper
naturally curls up towards
the top of the printer as
it exits the printer (see
illustration).
3. Gently close the door.
The AATpR10 uses rolls of thermal paper:
58 mm (2.25 inches) wide
n
20mm (23mm or 13/16 inch maximum)
n
diameter
65u thickness.
n
53 – 64 g/m2 weight
n
Thermally active side facing the center
n
of the roll
Additional rolls of paper may be purchase from
your Argus Analyzer's dealer. please request:
Thermal paper Refills, part #: AATpRRM10
containing 10 rolls of paper.
Larger diameter rolls can be purchased and re-
rolled to make smaller rolls of 23mm maximum
diameter. paper must be rolled with thermally
active side facing the center of the roll.
If you have questions or suggestions on how
Argus can serve your needs more fully, please
visit the support section of our web site.
www.argusanalyzers.com/support/index.htm
EN
5