Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION INSTRUCTIONS
FUNCTION
POWER
FLAME
HEATER
TIMER
FLAME SPEED
COOL DOWN CYCLE
A581
ICON
DESCRIPTION
The power button supplies power to all of the functions
of the fireplace. The power button will put the insert in a
standby mode. This will turn off all functions at once but
will hold the settings in the memory. By pressing the
Power button again the unit will turn on at the same
settings.
With the power on press and hold the Power button on
the control panel for 10 seconds to disable or re-enable the
heater function. Once disable or re-enabled the emberbed
lights will flash multiple times.
There are 5 brightness levels that can be selected and the OFF
(00) setting .
Settings F5- F1 decrease in brightness.
The fireplace contains three infrared quartz heating
elements.
The up and down buttons "
temperature setting.
The thermostat setting range is 62°F - 82°F (17°C - 27°C) or
continuously ON. To set flame effect so that it works without
heat, press the heater button until the display shows "00".
The thermostat is adjustable by 2°F or 1°C increments.
Pressing the timer button will cycle through the timer
settings; 30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H, 7H, 8H,
9H and off (00).
To change between °F and °C press and hold the TIMER
button on the control panel for 3 seconds.
Te fame speed is only adjustable from the remote control.
Setting S1 is slowest ranging up to setting S5 which is the
fastest.
After the fireplace has ran the fan will continue to run for a
COOL DOWN CYCLE period of time to cool down the
internal parts.
5
" will increase / decrease
www.tsicustomerservice.com
Publicidad
