Descargar Imprimir esta página

Milwaukee 2941-20 Manual Del Operador página 4

Bomba de vacío de 142 l/min (5 cfm) m18 fuel

Publicidad

Idiomas disponibles

Idiomas disponibles

SYMBOLOGY
Volts
Direct Current
Low Battery
Power Button/LED
Manifold Mode On/Off
Valve Open
Oil Fill
CFM
Cubic Feet per Minute
Read Operator's Manual
UL Listing for Canada and U.S.
FUNCTIONAL DESCRIPTION
4
3
2
1
10
1. Oil level window
2. Oil fill cap
3. Gas ballast valve
4. Carry handle
5. Intake fittings
5
9
6. Low battery indicator
7. Power button/LED
8. Manifold mode button
9. Isolation valve
10. Oil drain
WARNING
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
may be hazardous.
WARNING
Only use oil specifically refined for deep vacuum
pumps.
1. Twist open the oil fill cap.
2. Slowly add oil into the oil reservior
until level is between the MIN and
MAX markings.
3. Replace oil fill cap.
4. Monitor oil level during use.
6
7
When using a manifold, turn on Manifold mode for
8
best performance.
When battery capacity reaches 5 minutes of runtime
remaining, the pump will enter low battery mode. The
low battery LED will light and a buzzer will sound.
The pump will reduce in speed to conserve runtime
and maintain vacuum. Replace battery.
If the power button LED begins blinking, the tool has
entered thermal overload protection and cannot be
restarted until the pump has cooled down.
For best performance, use vacuum rated hoses
directly connected to the pump that are as short
and of the widest diameter possible. Inspect hoses
before operation and replace if worn. When using a
manifold, a 4-port manifold is recommended.
4
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
Always remove the battery pack
any time the tool is not in use.
Only use accessories specifically
recommended for this tool. Others
Adding Oil
Add oil before initial use. Do not
operate pump without oil.
Isolation Valve
Open
Manifold Mode
Low Battery Mode
Thermal Overload
Selecting Hoses
Closed

Publicidad

loading

Este manual también es adecuado para:

2941-21