Bosch GBM 10 RE Professional Instrucciones De Servicio página 14

14
| English
Intended use
The machine is intended for drilling in wood, metal, ceramics and
plastics.
Machines with electronic control and right/left rotation are also
suitable for screwing and threadcutting.
Machine elements
1 Key chuck
Noise/vibration information
Measured values determined according to
EN 60 745-1.
Typically the A-weighted noise levels of the product are: sound
pressure level: 93 dB (A); sound power level: 104 dB (A).
Tolerancia k=3 dB
Wear ear protection!
The typical weighted acceleration is 16 m/s2.
Assembly
Inserting the accessory
Key type chuck (fig. A)
Open the chuck wide enough so that the tool
can be inserted.
Insert the accessory and tighten all 3 bores 6 equally with the
chuck key.
Caution! The chuck may be very hot: During longer
working periods, the chuck can become very hot. In
this case we recommend wearing protective gloves.
Screwdriver Tools (fig. B)
When using screwdriver bits 7, a bit holder 8 should always be
used. Use only the screwdriver bits that fit the screw head.
F 000 622 264 | 10.2011
GBM 10 RE Professional.indd 14
2 Lock-on button for On/Off switch
3 On/Off switch
4 Rotational direction switch
5 Chuck key
*Not all of the accessories illustrated or described are included
as standard delivery.
Operation
Initial operation
Do not drill, fasten or cut into blind areas where electric, gas or
water lines may exist. Use appropriate detectors to determine
if these lines are hidden in the work area or call the local utility
company for assistance.
Contacting electric lines may cause fire or electric shock.
Striking a gas line will probably result in explosion. Breaking into a
water pipe will cause property damage or may cause an electric shock.
Check for correct mains voltage: The voltage of the power source
must agree with the voltage specified on the nameplate of the machine.
SWITCHING ON AND OFF
Brief activation
Press or release the On/Off switch 3.
Continuous use
Switching on: Press On/Off switch 3 and retain with locking button 2.
Switching off: Press and release On/Off switch 3.
STEPLESS SPEED CONTROL
The machine runs with variable speed between 0 and maximum
depending on the pressure applied to the On/Off switch 3.
Light pressure results in a low rotational speed thus allowing
Bosch Power Tools
29/11/11 08:59