Fluval FX UVC Manual De Instrucciones página 5

below the level of the receptacle or the connector if an
extension cord is in use, to prevent the water from travelling
along the cord and coming into contact with the receptacle.
If plug or receptacle gets wet, DO NOT unplug the cord.
Disconnect the fuse or circuit breaker that supplies power to
the receptacle then unplug the power supply and examine for
the presence of water in the receptacle.
13. This appliance contains a UVC emitter. Unintended use of
the appliance or damage to the housing area may result in
radiation. Exposure, even in small doses, may cause harm to
eyes and skin. Damaged units should not be in operation.
14. WARNING – Disconnect all appliances when performing
maintenance.
15. The appliance is to be supplied through a residual current
device (RCD) having a rated residual operating current not
exceeding 30 mA.
16. This appliance is a UVC water clarifier for use in ornamental
household aquariums. Do not use the appliance for any
purpose other than that for which it is intended. The use
of attachments not recommended or sold by the appliance
manufacturer may cause an unsafe condition.
• Do not use this product in swimming pools or other
situations where people are immersed.
• This product is suitable for use with water temperatures
up to 35 °C.
• Do not use this product with inflammable or
drinkable liquids.
• To avoid overheating, always ensure the filter is pumping
water through the unit while the UVC is plugged in.
• This product should not be placed where it can fall into the
water. It should be placed in a dry and protected place,
with sufficient ventilation around it.
17. If an extension cord is necessary, ensure connection is
watertight and dust proof. A cord with proper rating should
be used. A cord rated for less amperes or watts than the
appliance rating may overheat. Care should be taken to
arrange the cord so that it will not be tripped over or pulled.
The connection should be carried out by a qualified electrical
installer. WARNING – Do not connect power to unit unless
unit is fully and correctly assembled. The unit must always
be fully filled with water when operating.
5