Bosch GLI Professional 14,4 V-LI Manual Original página 17

OBJ_BUCH-808-001.book Page 17 Friday, June 27, 2008 11:23 AM
Assembly
Battery Charging (Accessory)
Use only the battery chargers listed on the accessories page.
Only these battery chargers are matched to the lithium ion battery
of your cordless worklight.
Note: The battery is supplied partially charged. To ensure full capac-
ity of the battery, completely charge the battery in the battery charg-
er before using your power tool for the first time.
The lithium ion battery can be charged at any time without reducing
its service life. Interrupting the charging procedure does not damage
the battery.
The lithium ion battery is protected against deep discharging by the
"Electronic Cell Protection (ECP)". When the battery is empty, the
cordless worklight is switched off by means of a protective circuit.
Do not continue to press the On/Off switch after
WARNING
the cordless worklight has been automatically
switched off. The battery can be damaged.
The battery is equipped with a NTC temperature control which allows
charging only within a temperature range of between 0 °C and 45 °C.
A long battery service life is achieved in this manner.
Observe the notes for disposal.
Removing the Battery
The battery 5 has two locking levels, which are supposed to prevent
the battery from falling out in case of unintentionally pressing the bat-
tery unlocking button 4. As long as the battery is inserted into the
cordless worklight, it is held in position by means of a spring.
Bosch Power Tools
English | 17
1 619 P01 346 | (27.6.08)