Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Assembly Instructions:
Before assembly, make sure all parts are present. Compare parts with part-list below. If any part is missing or
damaged, do not attempt to assemble the product. Contact customer service for replacing parts.
Wrench (Y) included.
1. Assemble Foot adjuster (T2) to 2 Side panels (G).
2. Put the bottom panel inside, Left and right panels outside. Bottom panel-the flant side should be upside. No need
to screw
3. Put the back panel outside comparing left/right panels.
assemble with screws in the order from no.1, 2, 3, 4 as drawing.
4. Put the front panel even outside comparing left/right panels.
assemble with screws in the order from no.5, 6, 7, 8 as drawing.
5. Assemble the bowl and top panel first, with screws (no. 9-11)
then put it on the assembled parts, assemble with screws (no. 12-15)
This panel should be at the outside comparing to front/back panel.
Assemble the side tables:
6. Install the 2 connector at the back first with 4x Bolts.
7. Insert the sticker (B) into hole in back connector (b), and D into hole d of a new connector. assembly the connector
with 2 x Bolts.
8. Do the same for another side table.
9. Assembly the fire bowl (C) on the base with 3 x Bolts (T1).
10. Insert the ash drawer (D).
11. Put the charcoal grate (B) and BBQ Grill (A) on the fire bowl. Use the Grill with Grill support if necessary.
Now assembly is completed
Use Raincover (W) to protect your grill if not in use.
Set up on a flat surface, away from anything that could pose a fire threat. As this item is low to the ground, always keep
an eye on the fire.
A
BBQ Plate
B
Charcoal Grate
C
Fire bowl
D
Ash drawer
E
Base-top
F
Side table
G
Base-Side
H
Base-Front
I
Base-Back
J
Base-middle panel
K
Base-bottom
M
Grill
N
Grill support
1
1
1
1
1
2
2
1
1
1
1
1
1
T1
Bolts (m6*15mm)
T2
Foot adjuster
L
Connector
W
Rain cover
X
Poker
Y
Wrench
23
4
4
1
1
1
Publicidad
