Publicidad
Idiomas disponibles
Idiomas disponibles
Automatic Shut-Off
If no button on the measuring tool is pressed for approx.
120 min., the measuring tool will automatically switch itself
off to preserve battery life.
To switch the measuring tool back on after it has been auto-
matically switched off, you can either slide the on/off
switch (8) to the "Off" position first and then switch the
measuring tool back on, or press either the laser point mode
button (4) or the laser line mode button (5).
Temporarily Deactivating Automatic Shut-Off
To deactivate the automatic shut-off function, hold down the
laser line mode button (5) for at least 3 s (with the measur-
ing tool switched on). If the automatic shut-off function is
deactivated, the laser beams will flash briefly as confirma-
tion.
Note: If the operating temperature exceeds 45 °C, automatic
shut-off can no longer be deactivated.
To activate the automatic shut-off function, switch the meas-
uring tool off and on again.
Working with Automatic Levelling
Sequence of actions
On/off switch (8) in position "
Press the laser line mode but-
ton (5) once
Press the laser line mode but-
ton (5) twice
Press the laser line mode but-
ton (5) three times
Press the laser line mode but-
ton (5) four times
Point mode can be activated or deactivated regardless of the line mode setting:
Press the laser point mode but-
ton (4) once
Press the laser point mode but-
ton (4) twice
If the measuring tool is outside of the self-levelling range, the
laser lines and/or points will flash quickly.
Working without Automatic Levelling
Sequence of actions
On/off switch (8) in position " On"
Bosch Power Tools
Setting the Operating Mode
The measuring tool has several operating modes which you
can switch between at any time:
– Cross-line and point mode: The measuring tool gener-
– Horizontal line mode: The measuring tool generates a
– Vertical line mode: The measuring tool generates a ver-
– Point mode: The measuring tool generates two vertical
All operating modes, except point mode, can be selected
with or without automatic levelling.
Horizontal line
Vertical line
mode
●
On"
cross-line mode
●
–
–
●
cross-line mode
●/–
●/–
If, during work with automatic levelling, you switch to "work-
ing without automatic levelling" mode (on/off switch (8) in
position " On"), the first combination option of this mode's
indicators is always activated.
Horizontal line
Vertical line
mode
●
cross-line mode
ates a horizontal and a vertical laser line as well as two
vertical laser points, one facing up, the other down. The
laser lines cross at a 90° angle.
horizontal laser line in front of it.
tical laser line in front of it.
Positioning the measuring tool in the room displays the
vertical laser line on the ceiling beyond the top laser
point.
If the measuring tool is positioned directly against a wall,
the vertical laser line almost encircles the entire space
(360° line).
laser points, one facing up, the other down.
Point mode
"Working without
mode
automatic level-
ling" indicator (3)
●
●
–
●
●
●
–
●
●
●
●/–
–
●/–
●
Point mode
"Working without
mode
automatic level-
ling" indicator (3)
●
–
1 609 92A 4HE | (09.08.2018)
English | 19
Figure
B1
C1
D1
E1
B1
Figure
F1
Red
Publicidad
