eluxe NETSU Manual De Usuario E Instalacion página 26

Method of Usage
Method of Usage
Water Injection
When the water heater use at the first time or used again after outage for a long time,
should inject water. Open all valves in pipeline, and then turn on the hot water tap.
When the water continuously flow, it replies that water heater have been filled with
water. Turn off the hot water tap, kept cold water pipe valve opening, make sure that
cold water could automatically add after hot water usage. And make appliance has
always been filled with water.
Switch on power
Insert the power plug into reliable electric grounding outlet, switch on the power, the
power indicator will lighten, according to the following method to adjust the temperature
control knob, water heater immediately operates.
Temperature regulation
Adjust temperature by temperature control knob. Turn clockwise to raise the setting
temperature, turn anticlockwise to lower the setting temperature, and the temperature
adjustment range is about 75℃ at room temperature.
After setting the temperature, the water heater automatically work and the heating
indicator lights up.
When the water temperature reaches the setting temperature, the power will be cut off
automatically, and the heating indicator will light out to enter the heat preservation state.
When the water temperature falls in some period, the water heat automatically again
and the heating indicator lights up.
When set to "OFF", water heater will not work.
LOW HIGH
OFF
Temperature control knob