Interstuhl HUB Manual Del Usuario página 10

TABLE OF CONTENTS
_1. GENERAL INFORMATION
_2. SAFETY
_2.1. SYMBOL EXPLANATIONS
_2.2. SAFETY INSTRUCTIONS
_3. TECHNICAL INFORMATION
_4. ASSEMBLY AND USE
_5. CLEANING AND CARE
1. GENERAL INFORMATION
_Please follow all safety instructions. These operating instructions have been compiled by the
manufacturer and are part of the product. The information contained therein is intended for
the purchaser or user of the products. Carefully read through the operating instructions in their
entirety. Sensible and careful use of the product shall ensure the safety of the users as well as
the cost­effectiveness and long service life of the product. The manufacturer shall not be liable
for any damage caused by failure to comply with the operating instructions or any unauthorised
modification to the product.
_You can find additional information about the Casambi Xpress remote control and Vogel's 405
ExtraThin wall mount in the accompanying operating instructions from each respective manu­
facturer.
_Only use HUB products for non­residential seating and office spaces.
_Refer to any warnings, safety instructions or other labelling attached to HUB products.
_The user shall be solely responsible for any damage caused by improper use or failure to comply
with these operating instructions and the manufacturer shall assume no liability.
_The user is not permitted to make any safety­related modifications to the upholstered furniture.
_Interstuhl continuously works on further developing its models and the technology used. We
therefore reserve the right to make any changes on the basis of technological progress without
prior notice. Please understand that changes to the scope of delivery with respect to equipment
and technology are possible at any time.
_Please only position the products on level surfaces to prevent them from tipping.
_Only remove the packaging when at the final installation location.
Do not open the packaging using sharp or pointed objects.
_When the HUB products are put into operation, the electrical system must be connected to a
power supply which has a protective conductor.
_To find a suitable installation location for your upholstered furniture, please ensure that the
upholstered furniture is installed according to its intended use and is protected against direct
exposure to direct light and sunlight, as well as the effect of intense heat in order to minimise
fading of the cover material.
_For workplaces in long­term use, the selected materials must not exceed or fall below a reflec­
tance of between 0.15 and 0.75 in order to prevent glare due to glossy or excessively bright or
dark surfaces.
10
_5.1. FABRIC AND LEATHER
_5.2. ALUMINIUM PARTS
_5.3. ELECTRICAL COMPONENTS
_6. MAINTENANCE OF ELECTRICAL COMPONENTS
_7. DISPOSAL
_8. WARRANTY INFORMATION