Publicidad
Idiomas disponibles
Idiomas disponibles
GL1425C - Error Codes
030
PWR-Board data recovered
035
SENS-Board data recovered
120
HI-alert – Unit height has changed
130
Mechanical Limit during Grade-
Match / PlaneLok
140
Laser beam blocked
141
Time out – Alignment could not be
completed in the allowed time.
150
No receiver – HL760 not available
for single axis automatic function
152
No receiver - The laser searched
but could not find
153
Lost receiver - The laser found the
receiver but then lost it.
155
More than one paired receivers
are available during automatic
alignment function
157
Lost communication after an established
and started receiver operation
Any other code
Press "E" to confirm the error message. The laser reverts to default settings. Check pairing to RC1402,
HL760/CR700 or App.
Press "E" to confirm the error message. Check the laser accuracy.
Press "E" to delete the error message. Check laser elevation and laser setup.
Press "E" to delete the error message. Check laser elevation and laser setup.
Press "E" to delete the error message. Ensure no obstacles between the laser and HL760/CR700 receiver
during the operation. The receiver needs to receive the laser beam all the time during this function.
Press "E" to delete the error message. Check radio operating range/connection. Ensure the laser
setup is stable.
Press "E" to delete the error message. Ensure the HL760/CR700 has been switched on and is paired with
the laser. The HL760/CR700 may have turned off automatically. Check if receiver is within radio range.
Press "E" to delete the error message. Check the operating range for auto function and restart. The
receiver has been placed too far away, too high or too low. Check if the receiver has been placed
along the wrong axis. Place the receiver along the correct axis.
Press "E" to delete the error message. Make sure only one receiver is turned on.
Press "E" to delete the error message. Check the operating range for auto function and restart the
function. The receiver has been placed too far away.
Contact your service provider.
EN
Publicidad
