Publicidad
Idiomas disponibles
Idiomas disponibles
ENGINE
Maintenance,
repair, or replacement of
the emission control devices and sys-
tems, which are being done at the
customers expense, may be performed
by any non-read engine repair establish-
ment or individual. Warranty repairs must
be performed by an authorized engine
manufacturer's service outlet.
TO ADJUST THROTTLE
CONTROL
CABLE
1. The throttle control has been preset at
the factory and adjustment should not
be necessary.
If adjustment is
necessary, proceed as follows:
2. With engine not running, move remote
throttle control lever to "FAS'I _
position.
3. If throttle lever on engine touches high
speed stop, no further adjustment is
necessary.
If throttle lever does not
touch high speed stop, continue with
adjustment procedure.
4.
Loosen cable clamp screw.
5. Move throttle lever up until it touches
high speed stop, and hold in this
position.
6. Tighten cable clamp screw securely.
Clamp Screw
Casing
"_
and Wire _
"_
"Z-
Governor Control Lever _
TO ADJUST
CARBURETOR
The carburetor has been preset at the
factory and adjustment should not be
necessary.
However, engine perfor-
mance can be affected by differences in
fuel, temperature, altitude or load. If the
carburetor does need adjustment, contact
your nearest authorized service center/
department
IMPORTANT:
Never tamper with the
engine governor, which is factory set for
proper engine speed.
Overspeeding the
engine above the factory high speed
setting can be dangerous.
If you think the
engine-govemed
high speed needs
adjusting, contact your nearest autho-
rized service center/department,
which
has the proper equipment and experi-
ence to make any necessary adjust-
ments.
18
Publicidad
