Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
FRONT PANEL
iwawid
ol
OkHz
CHI
iy
Cl) 0.
0 MHz
&
UMEMO|
30CH
T STATION
DISPLAY
SYSTEM
Fig. 4
DESIGNATIONS AND FUNCTIONS OF PANEL CONTROLS
0
@
POWER
(Power ON/ OFF Switch)
The unit works 2-3 seconds after this switch is turned on.
TEN
KEYS
(Ten Key Buttons)
Used to specify numbers for Memory, Auto Memory
and
Preset Call. Channels
1-30 can
be specified
using these
buttons.
Preset Call Setting Method
A station that has already been preset can be fetched by the
following method.
Pressing [, 21, CENTER ] in order fetches the station
present
in memory
for channel
12.
ENTER
(Enter Button)
Used for setting Memory, and preset Call.
TUNING
(Tuning Buttons)
Used
to change
the
received
frequency
to a higher
frequency
(UP) or a lower frequency
(DOWN).
BAND
(Band Button)
Selects between
FM or AM.
TU-460L:
Pressing this button changes the tuner from FM
to MW
to LW, then back to FM, in that order.
ANTENNA
(Antenna Switching Button)
Use this button to switch the antenna to receive a cable
station or a regular station.
The antenna modes can be stored in the memory.
AUTO
MUTE/MANU
(Tuning
Mode
Button)
This switches between auto and manual tuning.
Auto tuning: When the UP key is pressed, the radio is tuned
automatically to a higher frequency. Press the DOWN
key
to tune to a lower frequency. Use this position to eliminate
noise when no signals or weak signals are being received.
Manual tuning: In this position, the radio can be tuned
manually.
TU-460L:
Not available in this model, during reception of
LW only.
MEMORY
(Memory Button)
Used
to store
the frequency
of the station
currently
received.
Pressing (MEMORY_], (0, [2 CENTER 1] in order stores the
station on channel
12 in memory.
Up to 30 channels
of
either FM
or AM
can
be stored
in memory.
19)
©
MEMORY
(Memory Indicator)
This
indicator
lights when
the MEMORY
button
@ is
pressed.
CHANNEL
(Channel
Indicator)
This
displays
the number
of the channel
at which
the
station
is stored.
DIGITAL
FREQUENCY
INDICATOR
Reception frequencies are digitally indicated with numbers.
The FM frequency unit is MHz; the AM frequency unit is
kHz.
SIGNAL (Signal Indicator)
This lights when
a station can
be received.
STEREO/MONO
(Stereo/Mono
indicator)
"STEREO"
lights automatically when
receiving a stereo
broadcast.
"MONO" lights when receiving a monaural broadcast or no
broadcast at all.
TUNING
MODE
(AUTO/MANUAL)
Pressing MODE @ causes "AUTO" and "MANUAL" to light
up alternately.
TU-460L:
Pressing this button does not switch the tuner to
Auto Tuning
Mode,
during reception
of LW
only.
SIGNAL (Signal-Strength Indicators)
The number of LEDs that light increases in correspondence
with the strength of the signal being picked up by the
antenna.
ANTENNA
(Antenna Indicator)
The "NORMAL" or "CABLE" LED lights to indicate whether
in the normal or cable mode (controlled by key @).
Publicidad
